MS5908C Circuit Analyzer 220V TRMS vikiwat.com

Rating:

MS5908C Circuit Analyzer 220V, TRMS. It is a special test device designed for AC low-voltage distribution line quick fault location. TRMS measuring AC voltage. Artificial load 5A, 8A, 10A measuring line drop. Measuring phase voltage, neutral line (zero line) voltage to earth, peak voltage, frequency. Measuring phase (live line), neutra...

Rate this product Add to wishlist

Manufacturer: MASTECH

Warranty: 12 months

-10%

Price: 116.10лв. VAT Incl.

The offer is valid from 11.02.2019 to 17.02.2019

List Price: ~~129.00лв.~~ VAT Incl.

Discount: 12.90лв. VAT Incl. (10.00%)

SKU: 13965

Weight: 0.300 Kgs

Quantity: 4

Application

The 220V Mesh Test Kit MS5908C provides a quick power grid test and analysis of its status. Real RMS voltage measurement. Defective current protection test. Potential difference between zero and ground wire. Circuit Load with 5.8 and 10A Current, Peak Voltage and Frequency. Fast contact test for phase, neutral and ground conductor distribution. Indication of absence of grounding.

Network Tester MS5908C

measurement of mains voltage - 85.0 - 265.0 Vac;

peak network voltage - 120.0 - 375.0 Vac;

load voltage - 10.0 - 265.0 Vac;

impedance phase, neutral and earth conductor - 0 - 3 Ohm;

zero-earth conductor voltage - 0.0 - 10.0 Vac;

defective current protection fault time - 1 - 6.5 ms;

defective current protection trip current - 30mA (6mA);

network frequency - 45.0 - 65.0Hz;

voltage drop - 0.1 - 99.9%;

current load - 5/8 / 10A.

Important!

1. Never exceed the limit values indicated on the scale for each measurement range.

2. Do not touch the uninsulated PM
measuring probes.

3. Never use the instrument to measure a voltage higher than 265VAC

4. When the value of the measured parameter is unknown, the instrument is set to the maximum range.

5. Before selecting another measurement parameter, remove the probes from the previous measurement.

6. When measuring impulse power supply, be aware that high impulse values can damage the unit.

7. The safe touch voltage is up to 60 VDC, 30 VAC rms.

8. Never measure impedance in a circuit with a supply voltage included. In the resistance measurement mode, do not measure the voltage. In the current measurement mode, do not measure the voltage.